Bridge Temp Signals Configuration

About

For construction staging that requires one-lane, 2-way, 3-way or 4-way traffic AND where use of 24/7 flagging would be cost prohibitive, Temporary Bridge Signals are the answer.


This 4 Part Lecture Series is the actual course I take my students through and will cover the following:

Lecture 1:___Intro

A great beginner lecture if you're new to temporary bridge signals.


This is an overview of bridge temp signals. General controller timing and cabinet setup is discussed.


A demonstration on a test board shows our example running.


Run Time: 16 minutes

Lecture 2:___2-Way Configuration

Lecture 2 of our Course.


This installment shows the easiest of configurations--2 Ways.


We explain controller programming, cabinet wiring and component installation along with the demonstration of our work on the testboard.


*Downloadable 2-Way cabinet prints are included.


Run Time: 22 minutes

Lecture 3:___3-Way Configuration

Lecture 3 of our Course.


This installment brings us to a new configuration--3 Ways.

If you understood Lecture 2 (2 Way Configuration), you should be able to easily grasp this.


We explain controller programming, cabinet wiring and component installation along with the demonstration of our work on the testboard.


*Downloadable 3-Way cabinet prints are included.


Run Time: 15 minutes

Lecture 4:___4-Way Configuration

Lecture 4 of our Course.


This installment brings us to yet another configuration--4 Ways.

We go into great detail about controller ring structure and the reason we phase signals the way we do. Controller programming, cabinet wiring and component installation along with the demonstration of our work on the testboard is covered.


*Downloadable 4-Way cabinet prints are included.


Run Time: 30 minutes

Total Run Time: 1 hr 23 min

© 2025 Street Smarts Traffic, all rights reserved